Posted on

1989 Yamaha Waverunner 500 Manual

download office for mac updates

If one didn't come with the ski, you will need flush kit to connect to the plug noted by dernst above. Older Yamaha skis did not have an actual bilge pump. They used a siphon system hooked to the pump, so it only works with the ski in the water and the engine running. Older manuals are hard to find for free. Best bet is probably look for an aftermarket manual on Ebay. For the bogging, I'd check the compression 1st.

Topcon 7500 Total Station Manual. It should be somewhere around 130-140 psi per cylinder. If the compression is good then the problem is most likely the carbs, which will need to be cleaned and/or rebuilt.

Clear, printable, bookmarked, searchable PDF Instant download Covers 1987, 1988, 1989, 1990, 1991 Yamaha Wave Runner WR500 1990 Yamaha Wave Runner LX WR650. Complete service repair workshop manual for the: Yamaha Wave Runner 500 WR500 This is the same. Yamaha WaveRunner 500 WR500 Manual. 1989 Yamaha WaveRunner 500. My cousin picked up an 89' wave runner 500. He said he ran it but it bogs down. I have never worked on a Yamaha wave runner. But I have worked on many. My cousin picked up an 89' wave runner 500. He said he ran it but it bogs down. I have never worked on a Yamaha wave runner. But I have worked on many marine engines. My cousin picked up an 89' wave runner 500. He said he ran it but it bogs down. I have never worked on a Yamaha wave runner. But I have worked on many. The best hang-out for Personal WaterCraft enthusiasts >PWC Jetski Specific Forums >Yamaha Jetski >1989 Waverunner 500 Reply. Best bet is probably look for an aftermarket manual.